Operation
CNGmass DCI
38
Hauser
14-7
611
Simulation current output active
15-0
612
15-1
613
15-2
614
15-3
621
Simulation frequency output active
15-4
622
15-5
623
15-6
624
15-7
631
Simulation pulse output active
16-0
632
16-1
633
16-2
634
16-3
641
Simulation status output active
16-4
642
16-5
643
16-6
644
16-7
651
Simulation relay output active
17-0
652
17-1
653
17-2
654
17-3
661
Simulation current input active
17-4
662
17-5
663
17-6
664
17-7
671
Simulation status input active
18-0
672
18-1
673
18-2
674
18-3
691
Simulation of response to error (outputs) active
18-4
692
Simulation of volume flow active
19-0
700
The process fluid density is outside the upper or lower limit values set in the "EPD"
function
19-1
701
The maximum current value for the measuring tube exciter coils has been reached,
since certain process fluid characteristics are extreme.
19-2
702
Frequency control is not stable, due to inhomogeneous fluid.
19-3
703
NOISE LIM. CH0
Overdriving of the internal analog to digital converter.
A continuation of the measurement is still possible!
19-4
704
NOISE LIM. CH1
Overdriving of the internal analog to digital converter.
A continuation of the measurement is still possible!
19-5
705
The electronics' measuring range will be exceeded. The mass flow is too high.
20-5
731
The zero point adjustment is not possible or has been canceled.
22-4
61
F-Chip is faulty or not plugged into the I/O board.
24-5
363
Current input:
The actual value for the current lies outside the set limits.
Byte-bit
Error No.
Short error description
→
ä
62
