5 Getting Started
Fieldgate FXA720
26
Hauser
5.3.3 Setting PROFIBUS DP bus parameters in FieldCare
Note!
• FieldCare uses the PROFIGate driver for Fieldgate FXA720. This should be configured before
the PROFIBUS DP parameters are set (The procedure is identical to that in Section 5.3.2)
When Fieldgate FXA720 is used together with FieldCare, the PROFIBUS DP baudrate is set in the
Fieldgate FXA720 CommDTM (PROFIdtmDPV1).
Procedure
1. Create your project as described in the extended Getting Started manual supplied on the
FieldCare CD-ROM.
2. Add the Communication device PROFIdtmDPV1 - this is the Fieldgate FXA720 CommDTM.
Right-click on the node (in our example it has been re-named Fieldgate FXA720) and select
"Configuration"
. The CommDTM for Fieldgate FXA720 appears
3. The board names are automatically taken from the node names set in the
PROFIGate
driver.
– Select the node you want to use
– Enter a station address
– Set the bus parameters for communication on the PROFIBUS DP network
– Press
"Apply"
to confirm the changes
– Repeat the procedure for any other nodes where FieldCare is to have access
– Press
"Close"
return to the main program.
Summary of Contents for Fieldgate FXA720
