Micropilot FMR56, FMR57 FOUNDATION Fieldbus
Operating menu
Hauser
141
Blocking distance
Navigation
Setup → Advanced setup → Level → Blocking dist.
Description
Specify blocking distance BD.
User entry
0 to 200 m
Factory setting
FMR56, FMR57: antenna 400 mm (15.7 in)
Additional information
Signals in the blocking distance are only evaluated if they have been outside the blocking
distance when the device was switched on and move into the blocking distance due to a
level change during operation. Signals which are already in the blocking distance when the
device is switched on, are ignored.
This behavior is only valid if the following two conditions are met:
• Expert → Sensor → Echo tracking → Evaluation mode =
Short time history
or
Long
time history
)
• Expert → Sensor → Gas phase comp. → GPC mode=
On
,
Without correction
or
External correction
If one of these conditions is not met, signals in the blocking distance will always be
ignored.
If required, a different behavior for signals in the blocking distance can be defined by
the Hauser service.
BD
A0023041
34
Blocking distance (BD) for bulk solid measurements
Level correction
Navigation
Setup → Advanced setup → Level → Level correction
Description
Specify level correction (if required).
User entry
–200
000.0 to 200
000.0 %
Factory setting
0.0 %
Summary of Contents for Micropilot FMR56
Page 197: ......
Page 198: ...www addresses endress com 71344036 71344036 ...
