Proline 200 HART
Operation options
Hauser
33
6.3.1
Operational display
Explanatory symbols for the measured value
Status area
• Depends on the device version, e.g.:
–
: Volume flow
–
: Mass flow
–
: Density
–
G
: Conductivity
– : Temperature
• : Totalizer
•
: Output
•
: Input
•
: Measurement channel number
1)
• Diagnostic behavior
2)
–
: Alarm
–
: Warning
The following symbols appear in the status area of the
operational display at the top right:
• Status signals
–
F
: Failure
–
C
: Function check
–
S
: Out of specification
–
M
: Maintenance required
• Diagnostic behavior
–
: Alarm
–
: Warning
•
: Locking (locked via hardware))
•
: Communication via remote operation is active.
1)
If there is more than one channel for the same measured variable type (totalizer, output etc.).
2)
For a diagnostic event that concerns the displayed measured variable.
6.3.2
Navigation view
Status area
Display area
The following appears in the status area of the navigation
view in the top right corner:
• In the submenu
– The direct access code for the parameter you are
navigating to (e.g. 0022-1)
– If a diagnostic event is present, the diagnostic
behavior and status signal
• In the wizard
If a diagnostic event is present, the diagnostic behavior
and status signal
• Icons for menus
– : Operation
– : Setup
– : Diagnostics
– : Expert
• ▸: Submenus
•
: Wizards
•
: Parameters within a wizard
• : Parameter locked
6.3.3
Editing view
Text editor
Correction symbols under
Confirms selection.
Clears all entered characters.
Exits the input without applying the changes.
Moves the input position one position to the
right.
Clears all entered characters.
Moves the input position one position to the left.
Switches to the selection of the correction tools.
Deletes one character immediately to the left of
the input position.
Aa1
Toggle
• Between upper-case and lower-case letters
• For entering numbers
• For entering special characters
