Endress+Hauser RSG40, Appendix To The Operating Manual

Graphic Data Manager

Device configuration, application setup

23

2.3

Setup - Inputs - Digital inputs

Settings for digital inputs for batch mode.

!

Note! 
Only settings relevant for batch mode are described here. For all the other digital input functions, 
see the Operating Instructions on the CD-ROM.

Fig. 5: 

Setup - Inputs - Digital inputs - Digital input x

Default batch number

only if "Batch number" - 
"Automatic"

Configure the default value of the batch number, to which the batch 
number is set if it is reset via control input.
User input: max. 9-digit.

16066/000 to 
16066/003

Reset batch number

only if "Batch number" - 
"Automatic"

Select the digital input that resets the batch number to its default value.

!

Note! 

The assigned input is automatically pre-configured!

Picklist: 

Switched off

, Digital input x

16068/000 to 
16068/003

"Application - 

Batch mode" 

menu items

Configurable parameters

(factory settings are highlighted in bold)

Direct access

code

"Inputs - Digital 

inputs" menu 

items

Configurable parameters

(factory settings are highlighted in bold)

Direct access

code

Function

Select the required function. Digital inputs are High active, this means the described effect is achieved by a 
high input. Low = -3...+5 V, High = +12...+30 V
The following functions are available:

"Switched off":

 digital input is not active.

"Control input": various control functions can be activated for batch mode using the digital input.

40000/000 to 
40000/013

Channel ident.

Description of the function of this input (e.g. "Batch 1 start"). User input: 16-digit. Factory setting: 

Digital x

40010/000 to 
40010/013

Action

Set up the function of the control input for batch mode:

"Start/end batch x"

: starts/stops external analysis (analysis only runs while the signal is High). Measured 

value acquisition for the graphic display continues. Batches are also started/stopped using this function.

"Reset batch number x": resets the automatically generated batch number to 0 (for Low -> High change)

"Batch x limit values on/off": switch the batch's limit values on/off.

40085/000 to 
40085/013

Copy settings

Copies settings from actual channel to selected channel. The last two positions of the channel ident. of the 
target channel are replaced by this channel number.

40110/000 to 
40110/013