F D C 3 3 0 0 U s e r M a n u a l
12
C H A P T E R T H R E E
13
F D C 3 3 0 0 U s e r M a n u a l
C O N T R O L A N D S T A T U S C O M M A N D S
help
This query-only command displays a list of the Distribution Chassis commands. To get help on a
particular command you would type
help
, followed by the command..
Query:
help
Chassis response:
All commands are displayed.
Query:
help port
Chassis response:
Information specific to the
port
command is displayed.
port
This command sets the serial port parameters of baud rate, data bits, parity and stop bits. If you
change these parameters they will be saved in non-volatile memory. Syntax is: port=b,d,p,s. Where:
b is baud rate: 9600, 19200, 38400 or 57600.
d is data bits: 7 or 8.
p is parity: o, e or n (for odd, even or none)
s is stop bits: 1 or 2
Set:
port=57600,8,n,1
Chassis response:
OK
(The serial port is reset with the new parameters)
Query:
port
Chassis response:
57600,8,n,1
Factory default setting:
19200,8,n,1
.
pwrstat
This query-only command shows the status of the power supplies and power inputs. The distribution
chassis is capable of having two power supplies (for redundancy) but the standard unit has only one.
The second is an option. The
pwrstat
response will show two characters - the first is for the stan-
dard power supply. The second is for the optional power supply. A ‘0’ means the power input is not
present, the power supply has failed, or the power supply is not installed (in the case of the optional
supply). A one ‘1’ means the power supply is good. An ‘x’ means the optional power supply is not
installed.
Query:
pwrstat
Chassis response:
1x
(The first supply (Power A) is good. The second
supply (Power B) is not installed.
reset
This command will cause a software reset.
Command:
reset
Chassis response:
OK
(The Chassis will reset.)
respmode
This command configures the way the chassis responds to commands. If you change this setting it
will be saved in non-volatile memory. Command syntax is: respmode = x, where x is either TERSE
or VERBOSE. The TERSE mode means that when a command is entered the chassis will respond
Summary of Contents for FDC3300
