M e r i d i a n I I U s e r M a n u a l
38
C H A P T E R T H R E E
39
M e r i d i a n I I U s e r M a n u a l
C O N T R O L A N D S T A T U S C O M M A N D S
resetlastgpswn
This command is for use with a GPS simulator Refer to
Appendix J - Operation with a GPS Simu-
lator
for more information.
resetleaphistory
This command is for use with a GPS simulator Refer to
Appendix J - Operation with a GPS Simu-
lator
for more information.
rticmode (Optional)
This command is only available if the RTIC option has been installed. Refer to
Chapter 11 - Real-
Time Ionospheric Corrections
for more information.
serialnumber
This command shows the serial number of the Meridian II.
Command:
serialnumber
MeridianII reply:
15080056
setantfltmask
This command allows you to enable or mask the GPS antenna fault. Parameter for this command is
either MASKED or ENABLED. Setting this command to MASKED will prevent the antenna fault
from creating an alarm condition. Some installations may need to mask this fault due to special
antenna situations like splitters or DC blocks that confuse the antenna detection circuit. The factory
default setting is ENABLED.
Command:
setantfltmask MASKED
MeridianII reply:
Antenna Fault Mask set to MASKED
setcaldelay
This command starts an interactive utility that allows you to change the clock calibration delay. This
setting is used to advance or retard the clock in order to compensate for antenna cable length or other
external hardware or cabling. See
Appendix E - Installing the GPS Antenna, Calibrate Your Re-
ceiver
for more details.
Command:
setcaldelay
MeridianII reply: Interactive utility is started.
setgpsdynmode
This command accepts a single argument: ON or OFF, to allow you to set the dynamic mode of op-
eration of the GPS Subsystem. By default, the unit is configured for static operation, so this setting is
OFF. It is important that the dynamic mode be set OFF when the instrument is in a static installation.
Summary of Contents for Meridian II
