M e r i d i a n I I U s e r M a n u a l
56
C H A P T E R F O U R
57
M e r i d i a n I I U s e r M a n u a l
H T T P S I N T E R F A C E
Stratum 16:
The server is unsynchronized. NTP clients will not use a
Stratum 16 server.
Source
This field will show the source of time which is usually GPS. If Meridian II is
configured as a Stratum 2 server then it will show the IP address of the
upstream Stratum 1 server.
Offset
This field shows the offset in seconds between the NTP system clock and the
GPS Subsystem clock. Positive implies that the NTP system clock is ahead of
the GPS Subsystem clock.
Leap Indicator
This field shows whether a leap second is pending. Leap second events occur
Bits
approximately every 2-3 years as announced by the International Earth Rotation
and Reference Systems Service (IERS). Possible indicator values are:
00:
Normal, locked operation.
01:
Leap second insertion event will occur after 23:59:59 UTC.
10:
Leap second deletion event will occur after 23:59:58 UTC.
11:
Fault. Unsynchronized state.
I/O Statistics
Time Since Reset, These fields show statistics accumulated since the last reboot of the system.
Packets Sent/Received,
Packets Sent Rate,
Packets Dropped
PTP: Status and Configuration Pages (Optional)
The fields on these pages show the status and the configuration for the optional PTP/IEEE-1588 pro-
tocol. If your Meridian II does not have PTP enabled then there will be no fields shown. For more
information on PTP and an explanation of the data fields on this page see
Chapter 4 - PTP/IEEE-
1588
.
Firmware: Firmware Status Page
The firmware status page shows part numbers and revisions for Meridian II firmware components
which are: Linux Root File System (RFS), Linux Kernel, GPS Subsystem, GPS Subsystem FPGA
and GPS Receiver. Meridian also has two Field-Programmable Gate Arrays which are: GPS Subsys-
tem FPGA and GPS Receiver FPGA.
Firmware: Linux RFS Upgrade Page
This page is used for upgrading the Linux RFS firmware. You must be logged in as “root” in order to
have access to this page. The latest released versions of Meridian II firmware are freely available on
the EndRun Technologies website. For detailed information on how to perform the upgrade either via
the network port, the serial port, or the HTTPS interface see
Appendix B - Upgrading The Firm-
ware
.
Summary of Contents for Meridian II
