M e r i d i a n I I U s e r M a n u a l
24
C H A P T E R T H R E E
25
M e r i d i a n I I U s e r M a n u a l
C O N T R O L A N D S T A T U S C O M M A N D S
wrt_sw_opt
Command to enable a software option. See
Appendix I - Soft-
ware Options
for information.
Detailed Command
Descriptions
accessconfig
This command starts an interactive script that will allow the root user to configure access limitation
via
telnet
,
ssh
and
snmp
to Meridian II. By default, the unit is configured to allow access by all
users. If you need to limit
telnet
,
ssh
or
snmp
access, e.g. for security reasons, you must run this
script as root from either the RS-232 serial I/O port or from a
telnet
or
ssh
session.
This script modifies these files:
/etc/hosts.allow
and
/etc/hosts.deny
. These are non-volatilely stored
in the FLASH disk
/boot/etc
directory. You must reboot Meridian II after running this script for the
changes to take effect.
Command:
accessconfig
Meridian II reply:Interactive script is started.
antfltmask
This command displays the current setting for the Antenna Fault Mask.
Command:
antfltmask
MeridianII reply:
Antenna Fault is ENABLED
caldelay
This command displays the current calibration delay setting for the GPS antenna cable. The al-
lowable calibration delay range is ±500,000 nanoseconds. See
Appendix E - Installing the GPS
Antenna, Calibrate Your Receiver
for more details.
Command:
caldelay
MeridianII reply:
+0 nanoseconds
clearalmanac
This command is for use with a GPS simulator Refer to
Appendix J - Operation with a GPS Simu-
lator
for more information.
cpuio
This command displays the current settings for the CPU Module outputs. See
Chapter 10 - Rear-
Panel I/O, Standard I/O
and
CPU Module Options
for more information. Below is an example
response showing the standard outputs on A and B, with an optional output on C.
Summary of Contents for Meridian II
