M e r i d i a n I I U s e r M a n u a l
56
C H A P T E R F O U R
57
M e r i d i a n I I U s e r M a n u a l
H T T P S I N T E R F A C E
Primary and
These fields will display ONLY if your Meridian II has the Dual Power Supply
Secondary Power option installed. See
Chapter 10 - Rear Panel I/O, Masking Dual Power
Fault Alarms
Supply Fault Alarms
for more information.
Faults: TFOM Fault Level Page
This is the threshold at which a signal loss fault will be asserted. See
Appendix A - Time Figure of
Merit
for more information. You can change the TFOM Fault Level by using the
settfomfltlvl
command. The factory default setting is 9, which is the maximum TFOM value.
Faults: Receiver Faults Page
This page lists all possible system fault conditions of the GPS Receiver. For details on each fault see
Appendix G - System Faults
.
Network: IPv4 Page
This page shows the IPv4 network configuration.
IPv4 Network Status
DHCP
By default, Meridian II will configure itself using the Dynamic Host
Configuration Protocol (DHCP). If you need to set up static IP configuration,
you must use the
netconfig
command via the console port. Thie field will
show whether DHCP is enabled or disabled.
Address, Gateway These fields show the settings for the IP address, gateway and netmask.
Netmask
To change these settings use the
netconfig
command via the console port.
Network: IPv6 Page
This page shows information related to the IPv6 network parameters. For more information on IPv6
see
Chapter 8 - IPv6 Information
.
Network: DNS Page
This page shows the IP addresses of the primary and secondary domain name servers.
Network: MAC Address Page
This page shows the media-access-control (MAC) address for both Ethernet ports (
eth0
and
eth1
).
NTP Page
The NTP Status page shows all information related to NTP operation.
NTP Status
Status
The stratum field has several possible values:
Stratum 1:
The server is fully synchronized and accurate.
Stratum 2:
The server is synchronized to a Stratum 1 server.
Stratum x:
The server is synchronized to a Stratum x-1 server.
Summary of Contents for Meridian II
