3
Installing ENDURA NCC0355
1. Install NCC0355 in an area of the vehicle that is in close proximity to a 12V
outlet. The location selected should allow the vehicle power adapter to
be connected without excessive stretching of the cable.
2. Select a flat vertical surface in the vehicle for attaching the mounting
bracket. Use the 4 sheet metal screws provided to fasten the smaller sec
-
tion of the bracket to the vehicle. Install the mounting bracket securely
and in a manner that allows the larger section of the bracket to be level.
(Width of smaller section is about 2.6” and width of larger section is 4.2”).
3. After the mounting bracket is installed, fasten NCC0355 to the bracket us
-
ing the 4 brass thumb screws provided. If required, install the charging
pod in NCC0355 before attaching the charger to the mounting bracket. See
section
Replacing A Charging Pod
below.
4. Two tie-down straps are included with NCC0355. Use the 9.5” strap to se
-
cure shorter radios (height 6” or less) or the 17” strap to secure taller
radios (height over 6”).
5. To attach the tie-down strap, slide the end without the plastic clip through
the narrow horizontal opening on the back of the charger (above status
LED chart), but do not yet attach the end of the strap to itself. Place the
radio in the charger, bring the strap over the radio, and insert the plastic
clip into the metal clip holder on the front of the charger. A clicking sound
confirms the clip is properly connected. At the back of the charger, pull
the end of the tie-down strap until it is relatively tight and then press it
onto itself.
6. To remove a radio secured with the tie-down strap, press the sides of
the plastic clip with your thumb and forefinger and lift the tie-down strap.
Note:
It may be easier to install the tie-down strap before NCC0355 is at-
tached to the mounting bracket.
