Initial Adjustment
After assembly and before turning power on position the rear roller using the "T"
wrench (refer to the drawing if needed). Make 3 turns clockwise to avoid the belt
from slipping.
If belt is too far to the left side:
1) Turn the left roller bolt 1/4 turn clockwise (tighten)
2) Turn the right roller 1/4 turn counterclockwise (loosen)
If belt is too far to the right side:
1) Turn the right roller bolt 1/4 turn clockwise (tighten)
2) Turn the left roller bolt 1/4 turn counterclockwise (loosen)
Belt Tension and Centering Set Up
12
Make 3 Turns
