EN
DURO
®
auto
Steady 37
Ref: AS201A&B-UM-TKI-0415-Rev. A
If the press force (from ground and chassis) on corner steady is too big, the motor will stop, even if the single
corner steady function button is kept pressed.
The single corner steady function is used to adjust the height of single corner steady a little.
Do not try to jack the caravan by this function, this could completely damage your caravan
chassis or floor.
Different caravan chassis/ floor have different situation for jack-up force. Using the single
corner steady function button have the possibility to completely damage your caravan
chassis/ floor. The stop setup on the single corner steady function is used to protect the
motor and control unit, it cannot protect your caravan chassis/ floor all the time(this due to
the various caravan models).
After operation, deactivate the
auto
Steady system by moving the slide switch (Fig. 8A) to “Off”-O on the
remote control. The LED (Fig. 8H) on the remote control will turn off. Store the remote control in a safe place
(out of reach of children or other unauthorized people).
Turn off the battery power isolation switch (23).
Before you start driving always make sure that the four steady feet are fully lifted! Please
check the one by one!
OPERATION - EMERGENCY DRAW BACK FUNCTION
If you forget to draw back the corner steady after using, the emergency draw back function will draw back the
corner steadies automatically when you connect the 13-pin (or 7-pin) plug to the towing vehicle’s socket.
The emergency draw back function is only for emergency situations if you forget to draw
back the corner steady. Never use this function as a normal draw back method.
The emergency draw back function still works even if the battery voltage is too low. It will
not function if the battery isolation switch is turned off.
OPERATION – MANUALLY OPERATION
In the situation that the caravan battery is discharged too much to automatically draw back the corner steady,
or there is a defect, you can also do this manually.
Place the original 19mm socket manual handle on the 19mm hex-head of spindle (Fig. 5A), and turn it until the
corner steady is completely draw back.
The speed for manually draw back the spindle would not quicker than 1round per second.
Also do not reverse it very quickly during manually turning. Otherwise, the motor and
control unit maybe damaged by the sink current.
Repeat this also on all others corner steady.
As soon as the battery is charged again, or the problem is solved, the automatic spindle will work again.
MAINTENANCE
To prevent the battery from becoming totally discharged during long periods of inactivity it must be
disconnected, fully charged and frost-proof stored.
Please check regularly that the spindle is free of any dirt, or debris that may have been picked up from the road.
Regularly grease spindle and corresponding screw nut. Dirt or corrosion of the
auto
Steady system spindles can
lead to premature shutdown!
Once a year have your
auto
Steady system maintained and visually inspected. This inspection must include all
the bolt/nut connections, the cables and electrical connections and lubrication of movable parts/joints.
In case of any failure or problem, please contact your
EN
DURO
®
auto
Steady
supplier.
TROUBLE SHOOTING
Should your
auto
Steady system fail to operate, please check the following:
Summary of Contents for AS201A
Page 1: ...z Model Number AS201A B Model AS201A B Modellbe eichnung AS201A B Numero de type AS201A B...
Page 2: ......
Page 46: ......
Page 47: ......
