4
14. PLEASE HANDLE THE UNIT WITH CARE.
15. DO NOT operate the heater with a damaged power cord or a damaged AC wall outlet. DO NOT operate the heater if
it has been dropped or damaged in any manner.
16. DO NOT USE THE UNIT AS A ROOM HEATER.
17. DO NOT run the power cord under carpeting. DO NOT cover the cord with throw rugs, runners or the like. Position
the power cord away from traffic areas where it may be tripped over.
18. To disconnect heater, turn the power switch to off, then unplug the unit.
19. To prevent the possibility of fire, DO NOT obstruct air intakes or exhaust openings in any manner. DO NOT use on
soft surfaces such as a bed where openings may become blocked.
20. Use this heater only as described in this manual; any other use not recommended by the manufacturer may cause
fire, electric shock or injury to persons.
21. Remote control
FCC INSTRUCTIONS
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the distance between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult EnerG+® at 1-866-967-7333 ext 227.
SAVE THESE INSTRUCTIONS.
5. CLEANING AND STORAGE
1. Turn the unit OFF and unplug the unit before cleaning.
2. Use only a soft cloth to clean the exterior. An air compressor or a vacuum cleaner can be used to clean the interior.
3. Do not use gasoline, paint thinner or other chemicals to clean the heater
4. Store the heater in its original box and keep in a cool, dry place.
6. SPECIFICATIONS
Power supply:
120 V/60 Hz
Maximum wattage:
1500 W
Weight:
8.5 kg (18lb 12 oz)
7. GROUNDING INSTRUCTIONS
This product is for use on a nominal 120 V circuit with a grounding plug that looks like the plug illustrated below. Make
sure that the product is connected to an outlet having the same configuration as the plug. If you use an extension cord,
make sure it also has a grounding plug. No adaptor should be used with this product.
