21
EG-PM1W-001 SMART HOME SOCKET
All brands and logos are registered trademarks of their respective owners
4.5. System
On the
System
page you can change the socket name, web-server
login data, time (set it automatically using the NTP server or manually
using the client computer),
Power Manager
interface TCP port and
password (for accessing by
Power Manager
software), update the
firmware and reset the configuration to the default values (works in the
same way as the hardware Reset button).
The socket name should refer to the device which is attached to this
socket. For example, if the socket is connected to the TV, then the socket
name should be set to “TV”.
Before the EG-PM1W-001 schedule can be set up, the internal clock
must be correct. Click
Sync with Client Time
to copy the time from the
client computer used to access the web server. Alternatively, if the option
Enable NTP
is set (it is set by default) then the time will be taken from the
NTP server. The device will try to connect with the server every 18 hours.
The first synchronization takes place in 15 seconds after clicking
Apply
.
For NTP time correction to work properly the device should have
access to the Internet and have a proper DNS server setting.
A password may be set to control access to the Power Manager
software. The password should be between 1 and 8 characters
The
Power Manager
software needs an open port to access the EG-
PM1W-001. By default, port 5000 is used, but this can be changed to any
other port except for port 80 which is always occupied by the web server.
Don’t forget to click
Apply
to save your settings.
