150W 1/3 SHEET SANDER ENB458SDR
Fig.4
3. Connect the vacuum cleaner (using a 35mm tube) to the
dust extraction port with adaptor provided. The dust will be
collected by the vacuum.
3. Switching on/off(Fig.5)
Use the On/Off trigger to start the machine and keep holding
it for continuous operation.
To switch the machine off, release the On/Off trigger
Always switch the machine on before it reaches the work
piece
Remove the sander from the work piece before switching off
Before putting the sander down, please make sure it has
stopped completely.
While working, please always hold the machine tightly at the
grip area.
Don’t apply too much pressure on the tool, best sanding
results can be obtained by only a suitable pressure; the
performance will not improve by applying more pressure on
the tool.
4. Locking button(Fig.5)
The locking button can hold the switch on position for
continuous running.
Please follow below step:
To lock the on/off switch, turn on the on/off switch and press
the locking button, release the trigger.
The sander will continue to operate until the locking button
is released.
To release the on/off switch, just press it again and then
release it to stop.
Fig.5
Locking button
