www.energeticlighting.com
INSTALLATION INSTRUCTIONS
4. Secure the fixture to the post by tightening both of the
lock screws on the base of the fixture (A).
Fig. 4
3. Slip the base of the fixture (A) over the mounting pole,
ensure that wires are not pinched between the post
and adapter and that the post is seated fully inside
the adapter (B).
Fig. 3
4
This fixture is warranted to perform free from defects for three years. If it fails to do so, you may
return it with proof of purchase to 13445 12th St., Chino, CA 91710 for replacement.
TROUBLESHOOTING
WARRANTY
Problem
Possible Solution
Corrective Action
Fixture does not light.
Circuit breaker trips
when light is turned on.
1. Power is off.
2. Incorrect wire connection.
3. Defective switch.
Crossed wires or power
wire is grounded out.
Verify wires are correctly
connected.
1. Check circuit breaker
or power switch.
2. Check wire splices.
3. Replace switch.
5
Printed in China
www.energeticlighting.com
A
Mounting Pole