Before and after installation
Before installation
»
Read this manual carefully before installation.
»
Have the installation and maintenance of the PV modules
carried out by qualified and authorized specialists only.
»
All installation instructions must be read and understood
before beginning the installation.
»
To avoid burns and other injuries, never touch the PV
module with bare hands.
»
The PV module must not be dismantled.
»
After installation or repair, check that the PV module is
working properly.
»
Should the solar module or parts of it be replaced, the
replacement module or spare parts must correspond to
the previous module type or the original parts.
»
Persons without specialist knowledge of the PV module or
the measures to be taken in the event of a damaged
module to avoid injuries or electric shock are not allowed
to approach the device.
»
Keep all permits and licenses for installing the solar
modules in a safe place.
»
Do not set up the solar module horizontally, as this can
lead to delamination or glass deformation.
»
The modules are not designed for use indoors or on any
means of transportation.
»
The nominal specifications according to the industry
standard are determined under conditions of 1,000 W/m2
Irradiance and 25 ° C (77 ° F) solar cell temperature.
»
The voltage and amperage can be significantly higher at
colder temperatures.
»
Children are to be kept away from PV modules and systems
at all times.
»
Leave the module in the packaging until installation.
»
Follow the packaging instructions and check the packaging
for damage. If the packaging is damaged, contact the carrier.
»
Do not expose the modules to any mechanical tension
when screwing them onto the installation system.
(Torsion)
»
Never step on the modules or put any mechanical loads
on them. Do not drop any objects on the modules.
»
Do not store any flammable gases in the vicinity of the
installation site.
»
Do not work alone. Work in a team of two or more people.
»
Make sure that the staff knows and adheres to the accident
prevention and safety regulations.
»
Secure the modules during installation, especially when
storing them on the roof. Only mount the modules in dry
and calm weather.
»
When handling tools on the junction box cable, be careful
not to damage the cable..
»
Partial shading of modules can considerably reduce the
power output of the system and damage the modules.
»
Small angles of inclination should be avoided as they can
lead to the accumulation of dirt on the glass at the edge
of the frame.
Page 3
e
