18
OPERATION PROCEDURE:
1.
Installs 2 pieces of 1.5V #3 batteries, then the screen will display as following “Drawing A” and have
“Bi” sound at the same time, then enter to the personal data setting and press “MODE” button for
confirmation. After that, it goes to the next step to the main menu as “Drawing B”.
Drawing A
Drawing B
2.
Get access to the set-up mode of TIME/DISTANCE/CALORIES/PULSE. When you are in each set- up
mode, for example in the time set-up mode, time value is blinking, you can use joggle wheel to adjust
the value and press “MODE” for confirmation. The set-up of DISTANCE, CALORIES & PULSE is the
same as TIME.
3.
With any signal been transmitted into the monitor, the value of TIME, DISTANCE, CALORIES start to
count up as Drawing C. When there is any function has been preset the target (TIME or DISTANCE
or CALORIES), the function will be counting down from the preset to zero while the training starts.
Once the target is achieved to zero, the monitor start to beep for 8 seconds, and the function will be
counting up from zero directly if the training is going. Press “MODE” button for confirmation and
skip to next set-up.
4.
In SCAN mode shown as “Drawing C”. RPM/SPEED/TM/DIST/CAL/PULSE will skip to display in every
6 seconds. The order is as follows.
Drawing C
5.
You can also press “MODE” button to select single function display except RPM & SPEED function.
The RPM & SPEED function will switch display.
Summary of Contents for XT 580
