Energotech EnergoControl T60-EH, User Manual

Press the icon        and enter Feature Settings.

Find the “Sensor Selection” option, press it and entry in setting interface.

Press the icon        of which sensor you want to calibrate.

Built in Sensor (Default):  Tap it to entry calibration screen

Remote Air Sensor: 

Tap it to entry calibration screen

Floor Sensor Only: 

Tap it to entry calibration screen

Select the chosen value, you must then offset the thermostat to reflect the tempera-

ture actually measured, air or floor.

Press the icon        twice to save and return to main display.

          Sensor Selection and Calibration

Sensor Selection. You can select which sensor should be used, there are five options:

•  Built in Sensor (default)

•  Remote Air Sensor (external sensor)

•  Floor Sensor Only (external sensor)

•  Built in & Floor Sensor

•  Remote Air & Floor Sensor

Note

: When you enable “Remote Air & Floor Sensor”, the floor sensor is used as a floor 

limiting sensor and is designed to prevent the floor from overheating.

Note

: The Remote Air Sensor must not be used for controlling electric underfloor heat-

ing. Only floor sensors are available or both (Remote Air & Floor Sensor) should be used.

If the optional air- or floor sensor is not supplied by Energotech, an 10 kΩ sensor must be 

used together with the thermostat.

Press the icon        and enter Feature Settings.

Find the “Sensor Selection” option, press it and entry in setting interface.

Press the icon        of which sensor you required.

Press the icon        twice to save and return to main display.

01

02

03

04

Temperature Calibration of the Sensors. You can calibrate the sensors with ± 5°C in steps 

of 0.5°C, in the following way:

01

02

03

04

05

06

16