Energotech EnergoControl T60-EH, User Manual

          Humidity Sensor - Calibration

This option allows you to calibrate the humidity sensor. You should only calibrate the 

sensor if the reading differs from the actual air humidity.

You can calibrate the sensor with ± 30% in steps of 1% in the following way:

Press the icon        and enter Feature Settings.

Find the “Humidity Selection” option, press it and entry in setting interface.

Press the icons           to adjust and set the measured room humidity.

Press the icon        twice to save and return to main display.

01

02

03

04

          Open Window Function

Function description: The thermostat turns the heat off for 15 minutes, if it detects that 

the temperature drops by more than three degrees in less than one minute.

You can enable or disable the this function in the following way:

Press the icon        and enter Feature Settings.

Find the “Open Window Function” option, press it and entry in setting interface.

Press the icon            or            to enable or disable the function.

Press the icon        twice to save and return to main display.

01

02

03

04

          Floor Temperature Limit

The function is available when the floor sensor is enabled. You can set a floor tempera-

ture limit between 20-45°C, the default is 28°C.

Press the icon        and enter Feature Settings.

Find the “Floor Temp Limit” option, press it and entry in setting interface.

Press the icons           to set the temperature.

01

02

03

17