48
Call 1-
800-347-9575
for Technical Support
8.1 Service Contracts
If you are not qualified or do not wish to perform the boiler maintenance yourself, contact
EnergyLogic for the location of our nearest dealer or service provider. Putting a service
contract in place is the best way to make sure that the required maintenance is completed
regularly and your system will operate reliably when needed, saving you both time and money.
8.2 Safety Warnings
– Lockout/Tagout
There are many potential hazards associated with working on this equipment, including
electricity, heat, heights, dust and chemicals.
Make sure the main electrical
circuit is off and locked out / tagged out prior to performing maintenance.
Wear
proper safety equipment for the tasks, including a HEPA quality dust mask to avoid inhalation
of ash dust when cleaning the heat exchanger or flue. Use suitable access aids/equipment
when working on the boiler. Do not climb on the boiler. General safety rules and precautions
should be followed at all times to prevent any accidents that could lead to personal injury or
property damage. Only those qualified should perform these tasks.
8.3 Monitoring System Performance over Time
EnergyLogic recommends that you monitor and record your system gauge readings regularly
over time, in order to diagnose issues that may arise. For example, if the pump vacuum gauge
initially read 2 inches Hg, but over time has risen to 10 inches Hg, it is an indication that the
fuel filter is most likely clogged up. Record the system gauge readings on your maintenance
schedule and log. Have this log handy if you call EnergyLogic for technical support.
8.4 Maintenance Schedule and Parts
The recommended maintenance interval and log is shown on the following page. Check your
local codes and regulations for maintenance frequency requirements that may take
precedence. Use of certain fuels or other conditions may require more frequent maintenance.
Make a copy of the maintenance log and use it to record the maintenance and system
performance readings over time. Contact your EnergyLogic dealer or call EnergyLogic for
service parts. EnergyLogic offers convenient annual maintenance kits and cleaning tools made
specifically for your boiler. Economical bulk packs of fuel and air filters are available as well.
The maintenance schedule is the minimum recommended, but if you see smoke
or have trip outs then the unit must be shut down and serviced immediately before running it
again. Increase the maintenance as your situation requires.
