2
1.2 General Warnings
The EnergyLogic burner is to be used only in the EnergyLogic boiler
provided. Do not attempt to use the burner for other purposes.
Do not tamper with the unit or controls
– call your service technician.
Do not attempt to use unit with broken or damaged components.
Do not allow unqualified personnel to install or service the boiler,
electrical system, or flue system. Contact EnergyLogic for help with finding a qualified
installation and service company. Failure to install and maintain your boiler properly will
void your warranty and the UL listings.
Do not attempt to start the burner when excess oil has accumulated,
when the boiler is full of vapor, or when the combustion chamber is very hot.
Do not start the burner unless all cleanout panels are secure in place.
KEEP THE FUEL VALVE NEAREST THE SUPPLY TANK SHUT OFF
WHEN THE BURNER IS SHUT OFF FOR EXTENDED PERIODS.
Turn off power to the burner when the burner is off for extended periods.
The boiler is designed to be installed in a manner that restricts its access.
USED OILS CONTAIN HEAVY METALLIC COMPOUNDS AND
FOREIGN MATERIALS. WHEN BURNED, THESE COMPOUNDS ARE EMITTED
FROM OR DEPOSITED WITHIN THIS HEATING APPLIANCE AND THEREFORE
CARE SHOULD BE TAKEN WHEN USING, CLEANING AND MAINTAINING THIS
EQUIPMENT.
EnergyLogic recommends that the building, domestic hot water system or
process have a secondary heat source during times the boiler is down for maintenance
or service. Used oil boilers require maintenance. Also, used oil may sometimes be
unavailable or burn poorly due to contaminants (such as water) in the oil.
1.3 Safety Hazards
There are potential hazards associated with operation of this or any other boiler. In addition to
the codes and regulations listed in the following section, general safety rules and precautions
should be followed at all times to prevent accidents that could lead to personal injury, death or
property damage. Only those qualified should perform the tasks. Specific safety hazards
include:
Electricity: The EnergyLogic boiler operates on 115V/60Hz electrical power.
Turn power off at the circuit breaker and lock it out prior to performing any work on the boiler
system or any of the components. Make sure covers are in place during normal use. Use only
copper conductors.
Liquid Fuels: Used oils must be handled properly to prevent spills. Uncontained
oil leaks may contaminate the local water supply. Ensure that all national and local codes are
Call 1-
800-347-9575
for Technical Support
