© 2018 EnergyLogic, LLC Toll Free: 800 311 8828 Fax: 615 471 5202 www.energylogic.com 3
Rev. Date 062718
Caution & Safety
WARNING - TO REDUCE THE RISK OF ELECTRIC SHOCK OR INJURY TO PERSONS, OBSERVE
THE FOLLOWING:
a) Use this unit only in the manner intended by the manufacturer. If you have questions, contact
the manufacturer.
b) Before servicing or cleaning the unit, switch power off at the service panel and lock the service
disconnecting means to prevent power from being switched on accidentally. When the service
disconnecting means cannot be locked, securely fasten a prominent warning device, such as a
tag, to the service panel.
WARNING:
If unusual oscillating movement is observed, immediately stop using the ceiling fan
and contact the manufacturer, its service agent or suitably qualified persons.
WARNING:
Make sure to power the fan off and lock it out using the IEC/CE approved disconnect
when doing any cleaning and or maintenance to the equipment.
PRIOR TO THE INSTALLATION, ENSURE:
•
That the mounting of the suspension system shall be performed by the manufacturer, its
service agent or suitably qualified persons;
•
That the fan is to be installed so that the blades are more than 2,3 m above the floor;
•
The model or type reference of a luminaire that may be installed in a fan constructed for
this purpose.
DAMAGED EQUIPMENT
Do not operate or install any fans or fan accessories that appear to be damaged. Failure to follow
this instruction can result in death, serious injury, or equipment damage.
SERVICE:
If the fan does not operate properly using the procedures in this manual,
BE CERTAIN TO
REMOVE ALL POWER TO THE UNIT
and contact our technical department for further assistance.
Keep all body parts clear of moving part at all times. All electrical troubleshooting and repair
must be done by a qualified technician and meet all applicable codes.
Ensure that the replacement of parts of the safety suspension system device shall be performed
by the manufacturer, its service agent or suitably qualified persons.
Key Safety System Components
EnergyLogic fans are engineered with key safety features to prevent pieces of the fan from
falling in the unlikely event of a catastrophic failure. Used together, these features provide
comprehensive protection of people, equipment and property. Follow the detailed instructions
precisely when installing fans, including the following:
•
Install the safety cable on
EVERY
fan. The safety cable, if installed per EnergyLogic
specifications, will prevent the fan from falling in the unlikely event that the mounting
system should fail. An EnergyLogic fan should never be run without a properly installed
safety cable, which is supplied with every fan along with all required hardware. You must
install a safety cable for the warranty to be in effect.
•
Install guy wires on every fan, unless otherwise specified. Properly installing the guy wires
is required for proper stabilization during normal operation for some fan and mounting
types (Fixed Angle and Universal Mounts). In addition, guy wires keep the fan stable in case
of earthquakes or in “outdoor” installations where high wind conditions may occur.
