2. When the load is turned OFF manually, pressing the switch again turns the load
2. 100% , the maximum range of sensor's coverage is 1200 square feet( see
“COVERAGE PATTERN”)
Manual on function is achieved by using a momentary switch, such as the YQDS-
115-M momentary switch. The switch connected to the two grey wires(22AWG). Each
press the switch, the load will be reverted. The operation of the sensor connected
to manual switch depends on the DIP switch 2 setting.
Turn the lights on manually .When motion is no longer detected in a
selected time ,lights will change to OFF.When the selected time expires, the sensor
will change to ON automatically if motion is detected again in 30 seconds.
In this mode ,when motion is detected in the area ,lights turn on
automatically; When motion is no longer detected, light remain ON for a selected
time, when the selected time expires ,lights turn off automatically.
a. The load can be turned ON by manual switch activation and it stays on as long
as occupancy is detected. The sensor time delay operates as programmed. When
the load turns OFF due to lack of occupancy detection, the load can be turned ON
again by occupancy detection or switch activation.
b.Turn the lights OFF manually when it is ON.
1. When the load is turned OFF manually, as long as the sensor continues to detect
occupancy the load stays OFF. Selected time after the last occupancy detection,
the lights stay off and the sensor reverts to the automatic-on mode.
ON and the sensor reverts to the automatic-on mode.
3. Once the sensor returns to automatic-on mode, either the switch or occupancy
detection can turn the load ON
Vacancy Mode: DIP Switch 2
Enabled State :
Disabled State :
A manual switch provides the following additional functionality:
Enerlites Inc.
www.enerlites.com
Phone: 949-756-0536 Fax: 949-756-0528 e-mail:
sales@enerlites.com
Date:
03
/
01
/201
6
1. 50% , sensor’s coverage is smaller, just about half of the widest range.
DIP Switch Setting
The MPC-50V has 2 DIP switches under the cover. They are used to set sensitivity,
vacancy mode feature settings.
=OFF =ON
Sensitivity setting: DIP Switch 1
Sensitivity
50%
100%
Vacancy
Enabled
Disabled
1
2
=Factory Setting
