Enerpac EBC20B, Instruction Sheet

4

Max Diameter Alert: 

Cutting diameter must not 

exceed 20 mm [0.79 inch].

PPE Alert:

 Wear personal 

protective equipment 

(PPE) when using or 

servicing equipment

Instruction Manual Alert:

 Read the 

instruction manual before using or servicing 

equipment.

1.7  Crush Hazard

DANGER

Cutter will start immediately when 

battery is installed on cutter and on-off trigger is 

depressed.
DO NOT place hands, fingers or other parts of your 

body inside the cutting head unless battery is 

removed from cutter. Death or serious personal 

injury will result if cutter is started while persons are 

working inside the cutting head.

•  Never reach into the cutting head while cutter is in 

operation.

•  Before reaching inside the cutting head for any 

reason, always stop the cutter and remove battery.

been dropped, run over, or damaged in any way (e.g., 

pierced with a nail, hit with a hammer, stepped on, 

etc.). Damaged batteries should be properly recycled 

or disposed of, in accordance with all applicable laws 

and regulations in your country or region.

•  Do not store or carry the battery so that metal objects 

can contact exposed battery terminals.

•  Refer to manufacturer’s battery and charger manual 

for complete safety precautions, use and disposal 

instructions, and transport instructions.

•  Use the cutter only with a compatible battery of 

original equipment specifications. Use of a non-

compatible battery may result in erratic and/or unsafe 

operation.

1.5   Lithium-ion Batteries - Additional Safety 

Information

NOTICE:

DANGER

Failure to observe and comply with the 

following precautions will result in death or serious 

personal injury. Property damage could also occur.
•  Do not incinerate the battery even if it is severely 

damaged or completely worn out. 

The battery 

can explode in a fire. Toxic fumes and materials are 

created when lithium-ion batteries are burned.

•  If battery contents come into contact with the 

skin, immediately wash area with mild soap and 

water.

 If battery liquid gets into the eye, rinse water 

over the open eye for 15 minutes or until irritation 

ceases. If medical attention is needed, note that the 

battery electrolyte is composed of a mixture of liquid 

organic carbonates and lithium salts.

•  Contents of opened battery cells may cause 

respiratory irritation.

 Provide fresh air. If symptoms 

persist, seek medical attention.

1.6  Safety Symbols (on cutter)

  WARNING

Failure to observe and comply with the 

safety symbols affixed to the cutter housing could 

result in death or serious personal injury.

  WARNING

Make sure the safety symbols (decals, 

labels, etc.) are securely affixed to the tool and that 

they are legible. If not, obtain replacements from 

Enerpac. Refer to tool repair parts sheet for locations 

and part numbers. Failure to maintain safety symbols 

on tool could result in death or serious personal 

injury.

The following safety symbols are affixed to the cutter 

housing:

Crush hazard: 

Keep hands, fingers and other 

body parts away from the cutting head. 

Projectile hazard: 

Objects may be ejected 

from the cutter during operation. Stay clear of 

cutting area. Wear eye and face protection.