17
Figure 10, Fixed Blade Replacement
1
2
3
Key:
1. Fixed Blade Screws
2. Safety Guard
3. Fixed Blade
10.6.2 Blade Replacement - Fixed Blade
Replace the fixed blade as described in the following
steps. Refer to Figure 10, items 1, 2 and 3.
1. Be sure that the cutter piston is fully retracted. If not,
start the cutter and cycle the piston until it is fully
retracted.
2. Disconnect cutter from AC power supply to prevent
accidental motor startup during the following steps.
3. Place the cutter horizontally on a stable work surface
with the oil reservoir cap facing upwards.
4. Remove the fixed blade screws.
5. Remove the safety guard.
6. Remove the worn fixed blade and replace it with the
new fixed blade.
7. Reinstall the safety guard. Secure the safety guard
and the new fixed blade using the two new fixed blade
screws included with the new fixed blade. Apply
Loctite 243 thread sealant (or equivalent) to threads.
Torque to 18 ft-lb [25 Nm].
8. Test cutter for proper operation before placing it back
into service.
Summary of Contents for EBE26
Page 23: ...Notes...
Page 24: ...WWW ENERPAC COM...
