18
Figure 15, Fixed Blade Replacement
1
2
3
Key:
1. Safety Guard
2. Fixed Blade
3. Fixed Blade Screw
10.6.2 Blade Replacement - Fixed Blade
Replace the fixed blade as described in the following
steps. Refer to Figure 15, items 1 through 3.
1. Be sure that the cutter piston is fully retracted. If not,
start the cutter and cycle the piston until it is fully
retracted.
2. Disconnect cutter from AC power supply to prevent
accidental motor start-up during the following steps.
3. Place the cutter horizontally on a stable work surface.
4. Close the cutter safety guard to gain access to the
fixed blade screw hole.
5. Remove the fixed blade screw.
6. Open the cutter safety guard.
7. Remove the worn fixed blade and replace it with the
new fixed blade.
8. Close the cutter safety guard to gain access to the
fixed blade screw hole.
9. Secure the new fixed blade using the new fixed blade
screw included with the new fixed blade. Torque to
102 ft-lb [138 Nm].
10. Test cutter for proper operation before placing it
back into service.
Summary of Contents for ECCE32
Page 23: ...Notes...
Page 24: ...WWW ENERPAC COM...
