Enerpac ECH-202, Instruction Sheet

®

Instruction Sheet

Pull-down Clamps and Counter-holds

L2161    Rev C    10/01

Index:

English.........................................................1-4
Français .......................................................5-8
Deutsch .....................................................9-12
Italiano .....................................................13-16
Español ...................................................17-20
Nederlands ..............................................21-24
Portuguese ..............................................25-28

....................................................29-32

1.0  IMPORTANT RECEIVING INSTRUCTIONS

Visually inspect all components for shipping
damage.

Shipping damage is not covered by

warranty.

If shipping damage is found, notify

carrier at once. The carrier is responsible for all
repair and replacement costs resulting from
damage in shipment.

SAFETY FIRST

2.0  SAFETY ISSUES

Read all instructions, warnings,
and cautions carefully.

Follow

all safety precautions to avoid

personal injury or property damage during
system operation.

Enerpac cannot be

responsible for damage or injury resulting from
unsafe product use, lack of maintenance or
incorrect product and/or system operation.
Contact Enerpac when in doubt as to the safety
precautions and operations. If you have never
been trained on high-pressure hydraulic safety,
consult your distribution or service center for a
Enerpac Hydraulic safety course.

Failure to comply with the following cautions and
warnings could cause equipment damage and
personal injury.

A 

CAUTION

is used to indicate correct operating

or maintenance procedures and practices to
prevent damage to, or destruction of equipment
or other property.

A 

WARNING 

indicates a potential danger that

requires correct procedures or practices to avoid
personal injury.

A 

DANGER

is only used when your action or lack

of action may cause serious injury or even death.

WARNING:

Wear proper personal

protective gear when operating
hydraulic equipment.

WARNING:

Stay clear of loads

supported by hydraulics. A cylinder,
when used as a load lifting device,

should never be used as a load holding device.
After the load has been raised or lowered, it
must always be blocked mechanically.

DANGER:

To  avoid personal

injury keep hands and feet
away from cylinder and
workpiece during operation.

WARNING:

Do not exceed

equipment ratings. Never attempt
to lift a load weighing more than

the capacity of the cylinder. Overloading
causes equipment failure and possible
personal injury. The cylinders are designed
for a max. pressure of 350 bar [5,000 psi]. Do
not connect a jack or cylinder to a pump
with a higher pressure rating.

Never

set the relief valve to a higher

pressure than the maximum rated
pressure of the pump. Higher

settings may result in equipment damage
and/or personal injury.

WARNING:

The system operating

pressure must not exceed the
pressure rating of the lowest rated

component in the system. Install pressure
gauges in the system to monitor operating
pressure. It is your window to what is
happening in the system.