6
© 2015 Enerpac, All Rights Reserved
PTW Series Pneumatic Torque Wrench
6. Connect the air hose to the tool.
Fig. 4
7. Install the reaction arm onto the tool. Tighten the
setscrew to secure it on the tool.
Fig. 5
NOTICE:
Thread the setscrew in just deeply
enough to catch the retaining shoulder. Bottoming
out the screw can cause thread damage during
operation, making it difficult to remove.
8. Turn on the air supply.
4 OPERATION
!
WARNING: Before using the tool,
inspect the tool, reaction arm, air
hoses and Filter/Regulator/Lubricator
(FRL) for any cracks, wear or other
damage. Immediately replace any
worn or damaged parts with genuine
Enerpac parts before using the tool.
1. To rotate the tool clockwise, move the
lever to the “F” position. To rotate the tool
counterclockwise, move the lever to the “R”
position. There are 3 speeds for each direction.
3211
23
3211
23
Fig. 6
