TYPICAL RACK MOUNT
TYPICAL GROUND MOUNT
Attach headers to 2x6” lumber on each end. 2x6” lumber
may then be attached to roof using liquid adhesive
(Liquid Nails).
Ensure that the rubber is not blocking any roof drainage.
For safety reasons do not mount panels against a pool.
Rack plywood should be mounted 45
°
or less.
Support headers with 2x6” lumber. Panels may be set
on any material that will insulate them from the earth:
plywood, metal, plastic or gravel.
Note: Flat roof or ground mount panels will not gain
heat if sitting in any puddles of water. Ensure proper
drainage.
FENCE RACK
TYPICAL FLAT ROOF MOUNT
4
