017-220-J0 Rev C
12
Table A — Mechanical Specifications
Parameter
Value
Dimensions H x W x D
mm (in)
Std: 381 (15) x 305 (12) x 153 (6)
Weight kg (lb)
22.7 (50) with 4 batteries
11.3 (25) without batteries
Mounting
Wall or pole (with optional bracket Alpha Kit # 740-751-21)
Humidity
Operating: non-condensing up to 95% RH
Storage: up to 95% RH
Temperature, °C
Operating
Storage
–40 to 50°C (–40 to 122°F)
–40 to 75°C (–40 to 167°F)
Altitude, m (ft)
Operating
Storage
Up to 3700 (12,000)
Up to 4600 (15,000)
AC input and output connectors
3-position terminal block (maximum 12 AWG)
Dry contact ATC connectors
Terminal block, mating plug JITE p/n PTB750B-03-1-03-3 or equivalent (max 16
AWG)
USB connector
USB B
Ethernet connector
Optional, factory installed RJ-45
Dry contacts
Two programmable dry, single pole double-throw relays (C, NO/NC). Contacts are
rated at 28Vdc or 250Vac, 1A. The factory default settings are: C1: On battery, C2:
Low battery
Displays
Two LEDs (1 red and 1 green) via dry contact board
Enclosure Environmental
Protection Rating
Type 3R Enclosure (Equivalent to IP53)
Table B — Electrical Specifications
Parameter
Value
Input
Voltage (nominal), Vac
120 or 230
Frequency, Hz, ±3 Hz
60/50 (auto-frequency)
Current, A
2.0 @ 120Vac
1.0 @ 220/230Vac
Input circuit breaker
3.0A, 125Vac
1.5A, 230Vac
Output
Voltage (nominal), Vac
120 or 230 (± 10% on line mode, ± 2% on inverter mode)
Frequency, Hz, ±5%
60/50 (auto-frequency)
Current, A
0.83 @ 120Vac
0.43 @ 230Vac
Power, W/VA
100
Waveform
Sine wave
Load Crest Factor
3:1 (load dependent)
Output Voltage Distortion
< 3% THD (resistive load)
Efficiency
Utility Mode
Backup (Inverter) Mode
> 85%
> 75%
3. Specifications
Summary of Contents for Alpha Micro 100
