Enertech Bentone BG 450, Installation And Maintenance Instruction

GENERAL INSTRUCTIONS FOR 
GASBURNERS

Installation

1. 

Follow standards and instructions applicable to the 
installation of gas burners

2. 

Ensure that the electric installation is made in 
accordance with existing regulations

3. 

Check that the fresh air intake of the boiler room is  
sufficiently dimensioned

4. 

Check by studying the data plate that the efficiency 
of the burner is adapted to the boiler output

5. 

Check that the burner is adapted to the gas quality 
in question

6. 

Check that the input pressure of the gas is correct

7. 

Check that the dampers of the boiler are open

8. 

Check that there is water in the system

9. 

Check that thermostats etc. are correctly adjusted

10.  Read the instructions and follow the directions 

given for the burner as to starting-up and service

Maintenance

General instructions

1. 

Keep the boiler room clean 

2. 

Ensure that the fresh air intake of the boiler room is 
not restricted

3. 

Switch off the current and shut off the gas supply if 
the burner must be withdrawn from the boiler

4. 

Do not use the boiler for burning paper and waste 
if there is no special arrangement ( fire room ) for 
this

If the burner has stopped

1. 

Press the reset button of the relay

2. 

Check that the max. thermostat has not cut out

3. 

Check other thermostats for example room ther 
mostat, if any

4. 

Check that the gas pressure to the burner is 
sufficient

5. 

Check that the electric fuses have not blown

6. 

Make a new attempt to start the burner and check 
the counter of the gas meter to find out whether 
the solenoid valve opens

7. 

If the burner does not start in spite of repeated 
starting attempts call the installer

Normal operation

1. 

Ensure that the air supply to the burner is not 
obstructed  by dust and dirt

2. 

Have the installer make a yearly overhaul of the 
installation so that  safety is not jeopardized

3. 

Have the installer at the yearly overhaul also adjust 
the burner to ensure optimal combustion economy

4. 

Check periodically that there is water in the system 
( fill up if necessary ) and  that thermostats etc. are 
normally adjusted

5. 

Ensure that there is no water or dampness in 
contact with the burner

Shut-Off

1. 

Switch off the current with the main switch

2. 

Shut-off the gas supply with the shut-off cock on 
the burner

Warning

1. 

Never keep your face in front of the fire room door 
when starting up the burner

2. 

Do not use naked flame when inspecting the fire 
room

Authorized installer:

____________________________________________________________________________________________________

Address:_____________________________________________________________________________________________

Tel:_________________________________________________________________________________________________

170 025 05  2012-07-06