enertik GE-600-24, User Manual

4

B. Wind and solar hybrid power system for street light

C. Wind and solar hybrid power system for home

SOLAR PANEL

LED LIGHT

BATTERY

WIND SOLAR

HYBRID POWER

CONTROLLER

SOLAR PANEL

HOME

BATTERY

INVERTER

WIND SOLAR

HYBRID POWER

CONTROLLER

Wind and solar Hybrid power system configuration introduction 

5.1 Wind and solar hybrid controller

Wind and solar hybrid controller will be matched with the wind turbine according to different 
areas. The common controller has: PWM mode direct-charging wind and solar Hybrid control-
ler which is mainly used in high wind speed areas: MPPT mode boost controller which is 
mainly used in low wind speed areas.

5.2 Inverter

For customers who need AC power, it is recommended to use AC220V/50HZ or AC110V/130HZ 
Inverter, the capacity  should be determined according to maximum electricity load.

5.3 Battery

There are many battery choices available -lead acid, absorbed glass mat (AGM), gel cell and 
NiCad. The type of battery utilized will depend largely on the battery bank location and cost. 
For battery installations where fumes can be safely ventilated and the potential for acid 
leakage accommodated, the lead-acid battery is typically the most economical choice.

200AH/12V batteries are recommended for GE wind turbine owners. Negative pole of the 
battery should be a good grounding. The capacity must be based on electricity load of the 
owners.