enertik GE-600-24, User Manual

6

6.3 The wire leads of wind turbine and connection wires of battery should refer to wire 
requirement and regulations:

6.4 Please read carefully about controller instructions to set the functions after the completion 
of system wiring, such as model selection and regular time setting:

6.5 PV charging debug: in the light condition (output voltage of solar panel is greater than that 
of battery), the controller's PV indicator should be working (normal on or linking), measure 
output current by DC clamp meter, the current size depends on illumination intensity and 
battery capacity;

6.6 Wind turbine charging debug: wind turbine operation is normal or not when it is windy, 
while reach or exceed cut-in wind speed, the controllers wind turbine indicator should be 
working (normal on or blinking), measure output current by AC clamp meter, the current size 
depends on wind speed and battery capacity:

6.7 Light-control function debug: measure battery voltage by multimetre to ensure battery 
voltage is higher than over discharge recovery voltage, then set to light-control mode, discon-
nect any wire of solar panel from controler, several minutes later, observe whether the light of 
loads is on or not, it is normal it the light is on. Then connect the solar panel wire with control-
ler again. the load output is cut off a few minutes later and the light goes out:

6.8 Time-control function debug: ensure battery voltage is higher than over discharge recov-
ery voltage, observe whether the lighting time of load output light is the same as that of 
setting.

7 Maintenance

Although your high reliabity of wind turbine baa been designed to run for long periods with-
out requiring any maintenance, reliability and performance will be enhanced if you periodical-
ly inspect your system.

The following situations need regular maintenance:

Maintenance item

Check the rope tightness of tower

Check the working condition of the whole

system and connector tightness

Maintain battery (refer to battery manual)

Check all electrical connections to make sure

they are tight and free from corrosion

Wash off any built-up dirt or debris from the

blades and check blades for chip or nicks

Check damaged degree of nosecone

Replace blades

Replace battery

After

storm

Every

six

months

Every

year

Every

two

years

Every

five

years