142
READ FIRST
This instruction manual is intended for all the persons
involved in the installation of the Enervent ventilation
units. Only qualified professionals may install the
equipment described in this manual in accordance with
the instructions in this manual and the local laws and
regulations. If the instructions provided in this manual are
not followed, the warranty for the equipment becomes
void and damages may be caused to persons or property.
The equipment described in this manual may not be
used by persons (including children) with reduced
physical, sensory or mental capacity or without sufficient
experience or knowledge, unless a person responsible for
their safety is supervising and advising them in the use of
the equipment.
If the delivery does not contain all of the compo-
nents listed in the section ‘Contents of the delivery’,
please check the order and contact your distri-
butor or Enervent Zehnder before commencing
installation.
FOR YOUR INFORMATION
If you need technical support, please check the
equipment type and serial number from the type plate.
TYPE PLATE
IP 20
Type label
1234567890
Ventilation unit
TYPE:
W/ V/ HZ/ A: 1141/230,1~/50/6.1
www.enervent.com
Pallas HP eAir ventilation units are mechanical supply and
exhaust ventilation units with heat recovery. The heat
recovery is twofold, first using an integrated heat pump
to recover heat from the extract air, and second using a
rotary heat recovery wheel for even more energy efficient
heat recovery. The recovered heat can be transferred to
the supply air and to water (EnergyBUS model). The heat
pump process can be reversed to provide cooling of the
supply air in warm weather.
The Pallas HP eAir models include:
•
Pallas HP eAir with integrated heat pump
•
Pallas HP-E eAir with integrated heat pump and
additional supply air heating with electrical heating
coil.
•
Pallas HP-W eAir with integrated heat pump and
additional supply air heating with water circulating
heating coil.
•
Pallas eAir EnergyBUS KIW with integrated heat
pump and additional supply air heating with water
circulating heating coil. Ability to heat water with
integrated heat pump. Ability to use circulating air
ventilation when fresh air ventilation is not needed.
•
In addition, all Pallas HP eAir models can be equipped
with outside air pre-heater and extract air pre-heater
controlled by the unit’s automation.
Summary of Contents for Pallas eAir EnergyBUS KIW
