enervent Pinion, Operation And Maintenance Instructions

10

Service reminder display

The purpose of the service reminder is to remind the user 
when the service interval has elapsed. The maintenance 
interval is 4 or 6 months depending on the model. 

When the service interval has elapsed, the text 

FILS

 will 

be displayed on the screen.

Time for next service

Checking:

1

Simultaneously press buttons 

 and 

 once. 

2

Browse to the parameter n13 by pressing button  

. 

• 

The time remaining until the next service is displayed 
in days.

Set-up display

The set-up display is designed for professional use only. It 
displays the current settings in the ventilation system and 
enables changing the settings.

The system uses all of its devices in order to reach 

the required temperature. Missing devices, such 

as a cooling coil, may cause a higher temperature 

than the one you selected. 

Using Eco mode maximises heat recovery in 

warmer weather as well. However, it may also 

cause the supply air to be too warm. In this case, 

switch off Eco mode. 

NOTE:

ADDITIONAL FUNCTIONS

ADJUSTMENTS

Supply air is too warm

If the air coming from the ventilation system is too warm:

1. Go to a lower supply air target temperature by 

pressing button  

. The temperature value on 

the panel will change and the ventilation system 
will be adjusted according to the set target 
temperature.

Supply air is too cold

If the air coming from the ventilation system is too cold:

Go to a higher supply air target temperature by pressing 
the 

 button. The temperature value on the panel 

will change and the ventilation system will be adjusted 
according to the set target temperature.

The system uses all of its devices in order to 

reach the required temperature. Missing devices, 

such as an after-heating coil, may cause a lower 

temperature than the one you selected. 

Insufficient maintenance: Cold supply air can be 

caused by, for example, a blocked filter or the heat 

recovery’s worn-out drive belt.

See also the following section: Heating mode, on 

page 8 

NOTE:

Changing the settings is only allowed for an 

authorised person who has received sufficient 

training in using the ventilation system.

CAUTION