5
MODEL: EWB-QUAD24V-R
USER’S MANUAL
3. INITIAL ASSEMBLY
For ease of transportation and to reduce possible damage,
the batteries and the seat unit are packaged separately.
You need to assemble them on the main frame of your scooter.
OPENING THE PACKING BOX
Open the packing box of your new scooter and remove all protective liners,
and then remove the folded scooter from the box.
ADJUSTING ANGLE OF TILLER
• Loosen the lock-nuts (see fig. 4).
• Lift the tiller up to the correct angle.
• Tighten the lock-nuts to fix the tiller.
ASSEMBLE THE SEAT SUPPORT
• Insert the seat support into the seat tube located
on the rear section (see fig. 5).
• Align the bolt hole.
• Insert the bolt into the hole.
ASSEMBLE BATTERY UNIT
Put battery into trough, align electrode terminal on battery
with that in the trough, (see fig 6).
ASSEMBLE SEAT UNIT
• Put the seat onto the seat support (see fig 7).
• Pull out the seat-lock lever, adjust seat to the required position.
The seat will be locked automatically.
• Insert 1 left and 1 right armrest into the square tube separately.
• Adjust to the desired position and tighten lock-nuts.
ASSEMBLE NET-BASKET
• Remove the 2 screws located on the front of tiller (see fig.8).
• Assemble the net basket fixture to the front of tiller.
• Insert the net-basket into the fixture.
Note: The net-basket should be ordered separately.
LOOSEN THE LOCKED HANDLEBAR
• Turn the locked handlebar counter-clockwise to loosen it. (see fig 9)
FIGURE 4
FIGURE 6
FIGURE 7
FIGURE 8
FIGURE 9
FIGURE 5
CAUTION!
Please always keep electrode dean before installing.
If it is not clean, the contact between the battery packs and the electrode terminal may not be effective.
The scooter will not start if the battery is connected incorrectly.
