EnfaSafe SPIRIT 123, Instruction Manual

3.3.2. Adjusting the harness:

Tighten harness: Pull the adjuster strap until the harness lies flat and close against

your child’s body.

Note. The harness should allow 1 finger width, approx. 1cm at the top of the

shoulders for ideal fit.

Loosen harness: Press the centre adjuster and at the same time pull both shoulder

belts towards you. DO NOT pull on the shoulder pads.

WARNING! Do not add additional items such as blankets or padded clothing.

Bulky items can lead to incorrect harness tightening. In an accident the child

can slip out of the restraint if not properly tightened.

For the safety of your child, before every journey in the car check that...

- The child safety seat is engaged on both sides with the ISOFIX connectors

in the ISOFIX attachment points and that both buttons are green.

- The child seat is firmly installed in the vehicle.

- The belt is not twisted.

- The diagonal belt is only clamped by the lock-off which is located on the

opposite side from the car seat belt buckle.

- The straps of the child safety seat are close to the body without constricting

the child.

- The shoulder belts are correctly adjusted and straps are not twisted.

- The shoulder pads are at the same level as your child’s shoulders.

- The buckle latches are engaged in the harness buckle.

10