Battery
originating call.
Blinks on for 2s, off for 2s
for missed call.
ON solid during call.
for 10s
slowly i.e. every 10 seconds.
OFF if the battery charge
level is less than 5%
Active /
Aux
Blinks on for 500ms, off
for 1s, when receiving or
originating call.
Blinks on for 2s, off for
2s, for missed call.
ON solid during call
ON solid
Blinks on for 500ms, off
for 1s, when receiving or
originating call.
Blinks on for 2s, off for
2s, for missed call.
ON solid during call
Blinks on for 500ms, off for
2s during charge.
NOTE: The LEDs will blink when upgrading the firmware on the Mini MT.
2.4 Switches
Push To Call (PTC)
The Push To Call (PTC) switch allows the user to place a call to a number that has been programmed.
Set Geo-Fence Button
The Mini MT "ʘ" button is programmable through the event engine. The default state is to configure a ½
mile radius geo-fence at the current location. This radius may be re-defined and is retained in non-volatile
memory.
User-Defined Button
The User-Defined button "<" is programmable. Some examples of these functions include: generate a call
to a number different from the PTC button, generate a geo-fence with different parameters than the geo-
fence button, send an SMS of the current location to a cell phone, send the current location to the server,
etc.
Summary of Contents for Enfora Mini MT
