14.
You should see the following screen with the response from the Mini MT:
15.
The response “Enfora, Inc.” indicates that you are successfully communicating with the Enfora Mini
MT.
4.8 Demo Configuration to the Enfora Test Server
The Mini MT is capable of communicating with a server. The following steps will guide you through a
configuration that will demonstrate the data communication capabilities to the Enfora Test Server. A valid
SIM card from your carrier is required that allows GPRS data communications capability.
Reset the modem to factory defaults
To restore the Mini MT to factory defaults send the following command:
AT&F<CR>
To save the current configuration to memory send the following command:
AT&W<CR>
Reset the modem with the following command:
AT$RESET<CR>
Connecting the Mini MT to the Enfora Test Server
The following information will be required from the SIM card provider (refer to GSM0000AN019 – Network
Configuration Worksheet):
APN
Username (if required)
Password (if required)
SIM PIN (if required)
The following examples show how to configure the Mini MT with a Cingular SIM card with the following
data:
APN=isp.cingular
Username=ISP@CINGULARGPRS.COM
Password=CINGULAR1
SIM PIN=1234
Summary of Contents for Enfora Mini MT
