NOTE: This command, combined with the wakeup message, will allow the server to associate a
Public IP address with a specific modem and create a window of opportunity where the server can
send commands to the modem.
Configure the modem to talk with a specific server with the following command:
AT$FRIEND=1,1,”apitest.enfora.com”
Set the port number with the following command:
AT$UDPAPI=,1721
Enable periodic messages (wakeup) to be sent to the server every 60 seconds with the following command:
AT$WAKEUP=1,1
Configure the Mini MT for auto GPRS registration with the following command:
AT$AREG=2<CR>
Verifying Server connectivity.
For the following tests, Java Runtime must be installed on the computer. (To install Java Runtime, please
visit the Java website here: http://www.java.com/en/download/manual.jsp)
1.
Start Internet Explorer and enter the following URL:
“http://apitest.enfora.com/udpapp/”
2.
Enter the name used in the Modem ID (MDMID) command in the box.
3.
Select Connect.
4.
Select the tab with the modem name (MMT_Test). Within approximately 60 seconds wakeup
messages should be seen in the window.
NOTE: Selecting the Clear button will erase the contents of the “(ASCII Data):” window.
5.
Enter the following command in the Command / Data text box:
ATI
6.
Click on the Write button.
7.
Verify that you see the following modem response showing Enfora, Inc. If so, you have successfully
configured the modem to talk with the server.
Summary of Contents for Enfora Mini MT
