Enfora GSM1308 and GSM1318
Quad-Band Spider® SA-G+
User Guide
P a g e 23
Revision: 1.06
If AT$NETIP returns all zeros, send the following command: AT$CGEER<CR>
There are three common responses:
$CGEER: no PDP reject cause (Everything should be working OK)
$CGEER: requested service option not subscribed (APN is incorrect or SIM has
not been enabled for data mode.)
$CGEER: user authentication failed (username and/or password is incorrect.)
Configure the SA-G+ to access the Enfora Server.
Note: To configure the SA-G+ for server interoperability, several
things have to be addressed.
Most GPRS configurations are Mobile Originate only. The mobile SA-G+ must
initiate a conversation with a remote server before the remote server can talk to
the SA-G+.
IP addresses are dynamically assigned and can change.
Some IP addresses are NAT and are non-routable IP addresses.
These issues are addressed with the following configuration commands.
The examples will use the following information:
Modem
Remote Server DNS address = apitest.enfora.com
Remote Server IP port = 1721
Give the SA-G+ a unique name.
This command,
combined with the wakeup message, will allow the server to associate a Public
IP address with a specific SA-G+ and create a window of opportunity where the
server can send commands to the SA-G+
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from