ENFORCER
®
Flexible LED Strip
SECO-LARM
®
U.S.A., Inc
3
2.
The following ENFORCER 12VDC Power Supplies are ideal for use with the LED Strip:
Power Supply Model
Max. Supply Current
Number of Strips
ST-UV12-S0.5Q
0.5A
up to 2
ST-UV12-S1.0Q
1.0A
up to 4
ST-UV12-S2.0Q
2.0A
up to 9
ST-UV12-S5.0Q
5.0A
up to 24
Wiring
1.
Each LED Strip has a female pin connector at each end and one included 4-pin adapter.
2.
Connect the 4-pin adapter to either end of the LED Strip.
3.
Use the optional SL-SAS-PC1Q Power Connector (2.1mm) to connect the LED Strip to a
power adapter. Use a CA-161R DC Plug to Removable Terminal Block adapter if required.
LED Strip
4-pin adapter
(one included)
SL-SAS-PC1Q
(optional)
4.
If use of SL-SAS-PC1Q is not desired, the LED Strip pin connections are as follows:
5.
If at any time the strip fails to illuminate when power is connected, it is likely that the pins
have been reversed. Flip the power connector over or reverse the power connections to
correct the problem. The product is reverse polarity protected and damage will not result.
Connecting Multiple Units
(max. 30 strips)
1.
Up to 30 LED Strips can be connected together in series.
LED Strip
4-pin adapter
(one included)
LED Strip
2.
If any strip fails to illuminate when power is connected, flip end for end to reverse polarity.
3.
The LED Strip is reverse polarity protected so inverse connection will not cause damage.
WARNING:
DO NOT CONNECT MORE THAN 30 LED STRIPS IN SERIES.
Cutting the LED Strip:
1.
The LED Strip can be cut to length every 3 LEDs using wire cutters, tin snips or strong scissors.
2.
At any of the points shown below, cut as close to the mid-point between the LEDs as possible.
3.
If desired, the cut end may be covered with electrical tape or silicon sealant.
4.
Connect the shortened strip to the power supply. No further electrical connections are needed.
Adjusting Brightness
1.
The brightness of the LED Strip can be adjusted to three levels.
NOTE:
Brightness is not adjustable when using the SL-SAS-PC1Q power connector.
2.
Connecting a different number of +12VDC pins to the power supply will change the brightness
as shown in the chart on the following page.
Cut Point
Cut Point
Cut Point
Ground
+12VDC
Ground
+12VDC
