51
8. To edit phonebook entry:
a.
Use
or
scrolling key or the alphabetical search
method to locate the record to be edited.
b. Press
OPTION
soft key to enter editing menu.
c.
Press
2
to edit the designated phone entry.
9. Dial from display:
a. Press
TALK
or Intercom to dial the phone number or Handset
ID displayed.
10. To transfer phonebook:
To transfer phonebook, both parties have to enter the phonebook
transfer mode firstly by following below:
a.
Press
OPTION
follow by
4
or
or
scrolling key
when handset in phonebook mode.
b. For phone sending party, press
1
to enter sending mode.
Either press
TX ALL
(left soft key) to transfer all phonebook
entries to another handset(s).
Or press
TX ONE
(right soft key) to transfer one entry to
another handset(s).
Press 2-digit handset ID or group ID, then select all
phonebook entries or one entry to be transferred.
Re : “00” means all handsets
During phonebook transferring, LCD shows “Sending” and 2-
digit countdown on the LCD to indicate the phonebook
numbers which are waiting for sending.
c. For phonebook receiving party, press
2
to enter receiving
mode.
When entering the receiving mode, LCD shows “Ready”.
Start to receive phonebook, LCD shows “Get phonebook from
Ext. # : xx”.
A beep emitted when receiving each phonebook.
When the phonebook receiving, 2-digit countdown on the
LCD to indicate the phonebook numbers which are waiting
for receiving.
Re: The phonebook transfer through the wireless interface, it
may partially miss transmission by interference.
52
Repeater Operation
1. Due to the range performance of handset to handset calls
(intercom or broadcast) isn’t as good as line calls, in order to get
better range performance for handset to handset calls, install a
repeater and make the calls via repeater is the solution.
2. The procedure of repeater’s registration is same as the multi-base
which can be performed by administrator handset (Handset 10
and 11).
3. From an administrator handset (Handset 10 or 11), press
MENU
–
7
to enter the “BC/INT Type” menu setting.
4.
Press
or
key to select “Repeater Mode”, then press
SAVE
(Left soft key)to confirm the selection.
Re : When setting to “Repeater” mode, the handset to handset
calls will always via repeater.
5. Enter the base number (00~07) which assigned the base to be a
repeater.
6. The default of “BC/INT Type” is “P2P Mode”.
Notes:
Character Table:
Key
Characters and Orders
1
‘ + , .
＊
( ) & 1
2
A B C 2
3
D E F 3
4
G H I 4
5
J K L 5
7
P Q R S 7
8
T U V 8
9
W X Y Z 9
0
0
＊
Toggle case when in character editing
＊
P (Pause) when in number editing
#
Space – when in character editing
# when in number editing
