43
Using WDS (Wireless Distribution System) will allow
a network administrator or installer to connect to
Access Points wirelessly. Doing so will extend the wired
infrastructure to locations where cabling is not possible or
inefficient to implement.
Note:
Compatibility between different brands and
models of Access Points is not guaranteed. It is
recommended that the WDS network be created using
the same models for maximum compatibility.
Also Note:
All Access Points in the WDS network must
use the same Channel and Security settings.
To create a WDS network, please enter the MAC addresses
of the Access Points that you want included in the WDS.
There can be a maximum of four Access Points.
Note:
Only applicable in WDS AP and WDS Bridge modes.
2.4 GHz/5 GHz WDS Link Settings
Security:
Select None or AES from the drop-down list.
AES Passphrase:
Enter the Key Values you wish to use.
Other AP(s) must use the same key to establish WDS link.
MAC Address:
Enter the Access Point’s MAC address to
which you want to extend the wireless area.
Mode
: Select
Disable
or
Enable
from the drop-down list.
Save:
Click
Save
to confirm the changes.
WDS Link Settings
Summary of Contents for EAP1750H
