B
ASIC
N
ETWORK
S
ETTINGS
R
OUTER
S
ETUP
4-12
4.3 Router Setup
4.3.1 Configuring WAN Settings
Configure the WAN settings for the ENS200 using a static or dynamic IP address, PPPoE or PPTP.
Static IP
Setting a static IP address allows an administrator to set a specific IP address for the router and guarantees that it can not be
assigned a different address.
Account Name
Enter the account name provided by your ISP
Domain Name
Enter the domain name provided by your ISP
MTU
The maximum transmission unit (MTU) specifies the
largest packet size permitted for an internet transmission. The
factory default MTU size for static IP is 1500. The MTU size
can be set between 512 and 1500.
IP Address
Enter the router’s WAN IP address.
Subnet Mask
Enter the router’s WAN subnet mask.
Default Gateway
Enter the WAN gateway address.
Primary DNS
Enter the primary DNS server address.
Secondary DNS
Enter the secondary DNS server address.
Discard Ping on WAN
Check to Enable to recognize pings on
the ENS200 WAN interface or Disable to block pings on the
Summary of Contents for ENS200
