57
WDS Link Settings
Using the WDS (Wireless Distribution System) feature will
allow a network administrator or installer to connect to
Access Points wirelessly. Doing so will extend the wired
infrastructure to locations where cabling is not possible or
inefficient to implement.
Note:
Compatibility between different brands and
models of Access Points is not guaranteed. It is
recommended that the WDS network be created using
the same models for maximum compatibility.
Also note:
All Access Points in the WDS network need
to use the same Channel and Security settings.
To create a WDS network, please enter the MAC addresses
of the Access Points that you want included in the WDS.
There can be a maximum of four Access Points.
Note:
Only applicable in WDS AP and WDS Bridge modes.
2.4 GHz/5 GHz WDS Link Settings
Security:
Select
None
or
AES
from the drop-down list.
AES Passphrase:
Enter the Key Values you wish to use.
Other Access Points must use the same Key to establish a
WDS link.
MAC Address:
Enter the Access Point’s MAC address to
where you want to extend the wireless area.
Mode
: Select to disable or enable from the drop-down list.
Save:
Click
Save
to confirm the changes.
Summary of Contents for ENS500-AC
