58
10.2
LAN
This page allows you to modify the device’s LAN settings.
The LAN setting in Client Router mode.
There is additional setting
Default Gateway
in Repeater and Client Bridge mode.
LAN IP
Bridge Type
Select Static IP or Dynamic IP from the drop-down list. If you select Static IP, you will be required
to specify an IP address and subnet mask. If Dynamic IP is selected, then the IP address is
received automatically from the external DHCP server.
Note
: The option: Dynamic IP is only in Repeater mode.
IP address
The LAN IP Address of this device.
IP Subnet Mask
The LAN Subnet Mask of this device.
Default Gateway
The Default Gateway of this device. Leave it blank if you are unsure of this setting.
802.1d Spanning Tree
When Enabled, the Spanning Tree protocol will prevent network loops in your LAN network.
Summary of Contents for ERB9260
