001-01-000083 Rev. 001
Page 4 of 5
E. Optional Side Plate Installation
Threaded holes on both sides of the WR-10U frame allow
an optional side plate (Model SPL-4H) or additional cable
guides to be installed to expand cable management. The
SPL-4H provides two split and adjustable take-up reels,
as illustrated in Figure 5.
To install and use the SPL-4H side plate, refer to Figure
10 and the steps below.
c
Slide the two narrower tabs at the edge of the SPL-4H
into the openings on the side of the WR-10U, toward
the rear of the mounting.
d
Align the wide tabs at the front edge of the SPL-4H
with the threaded holes on the side of the WR-10U
frame. Use the two (2) included #10-32 x 3/8
” screws
to securely fasten the side plate to the frame.
e
Carefully wrap cables around the take-up reels to
reduce slack as needed. Example routing is shown in
Figure 11. Alternate mounting holes are included on
the side plate for repositioning the half-reels, if desired.
5. TESTING AND TROUBLESHOOTING
Each piece of equipment installed in the WR-10U should
be tested according the manufacturer’s instructions.
Figure 8. Cable guide installation
Figure 9. Cable guide application
Figure 10. SPL-4H installation
Figure 11. Cable take-up reel routing
